PCAN-USB Pro FD

• Adapter for High-speed USB 2.0 (compatible to USB 1.1 and USB 3.0)
• Transmitting and receiving of CAN FD and LIN messages using 2 D-Sub connections (both with pin assignment for the CAN FD and LIN bus)
• Time stamp resolution 1 μs
• 5-Volt supply at the D-Sub connector can be activated through a solder jumper, e.g. for external bus converter
• Voltage supply via USB
• Extended operating temperature range from -40 to +85 °C (-40 to +185 °F)

CAN operation properties

• Complies with CAN specifications 2.0 A/B and FD
• CAN FD support for ISO and Non-ISO standards switchable
• CAN FD bit rates for the data field (64 bytes max.) from 25 kbit/s up to 12 Mbit/s
• CAN bit rates from 25 kbit/s up to 1 Mbit/s
• FPGA implementation of the CAN FD controller
• NXP TJA1044GT CAN transceiver
• Each CAN FD channel is separately opto-decoupled against USB and LIN up to 500 V
• CAN termination can be activated through solder jumpers, separately for each CAN channel
• Measurement of bus load including error frames and overload frames on the physical bus
• Induced error generation for incoming and outgoing CAN messages

LIN operation properties

• Bit rates from 1 kbit/s up to 20 kbit/s
• TJA1028 LIN transceiver
• Compliant with all LIN specifications (up to version 2.2)
• Both LIN channels (common ground) are optodecoupled against USB and CAN FD
• Can be used as a LIN master or slave (1 ms master task resolution)
• Automatic bit rate, frame length, and checksum type recognition
• Autonomous scheduler with support for unconditional, event, and sporadic frames
• Hardware can work through a schedule table (up to 8 schedule tables can be configured with a total of 256 slots)